Ce Remove From Configuration - HP NetServer AA 4000 Administrator's Manual

Chapter 5

CE Remove From Configuration

This command removes CEn from the configuration, resets it, and reboots it. When the CE
reboots, it tries to rejoin the server. If you do not want the CE to rejoin the server, power it off
or use the CE Disable Operation command.
Warning: If only one CE is in operation, use a Windows NT Shutdown
command whenever possible. This command does not perform a
normal Windows NT shutdown. As a result, you can lose any data
in the disk cache that has not been written to the disk.
Command CEn Remove From Configuration From IOPx
Console Syntax MTCCONS CEn Remove From Configuration From IOPx
-disable_safeguard
Note: The
n – the ID number of the CE (1 or 2)
Variables
x – the ID number of the IOP (1 or 2)
Check the Windows NT Event Viewer for a message that indicates that the
Results
CE has been shut down, disabled, or removed from service.
See Also
CE Disable Auto Boot
CE Disable Auto Synch
CE Disable Operation
CE Enable Operation
-disable_safeguard
online or for the CE boot disk if the CE is running.
argument is needed only for the last IOP
Commands
85