To replace the component, reverse the removal procedure.
Removing and replacing the iLO Service Port cable
assembly
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
•
T-15 Torx screwdriver
•
T-10 Torx screwdriver
Procedure
1. If installed, remove the front bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
•
Extend the server from the rack.
•
Remove the server from the rack.
5. Remove the access panel.
6. Remove the air baffle.
7. Disconnect the iLO Service Port cable from system board.
8. Do one of the following:
68
Removal and replacement procedures