Ce Enable Operation - HP NetServer AA 4000 Administrator's Manual

Chapter 5

CE Enable Operation

This command enables a faulted or disabled CE, allowing it to join the active server.
Command CEn Enable Operation From IOPx
Console Syntax MTCCONS CEn Enable Operation From IOPx
n – the ID number of the CE (1 or 2)
Variables
x – the ID number of the IOP (1 or 2)
Results To verify that CEn has been enabled, either:
•
•
See Also
CE Disable Operation
CE Remove From Configuration
84
Issue an IOPx Show Configuration command from either IOP to make
sure that the CE and any associated components (such as CEn.MIC) are
active.
Check the Windows NT Event Viewer for a message stating that the CE
was enabled by operator request.
Commands