Chapter 5 - Commands; Issuing Endurance Commands; Accessing Endurance Manager Commands - HP NetServer AA 4000 Administrator's Manual

Chapter 5

Issuing Endurance Commands

You can issue the commands using either:
• Endurance Manager – the command syntax for this method is documented in the
Command section of each command.
• MTCCONS (the Endurance Manager Console) – the command syntax for this method is
documented in the Console Syntax section of each command. Refer to
MTCCONS information, including a description of the MTCCONS parameters.
Using Endurance Manager or MTCCONS, you can issue commands from:
• The CE operating system
• An IOP that is active in the server configuration
• A properly configured remote workstation that is running Endurance Manager
When using Endurance Manager, you can access the commands by the methods listed in
5-1.
Table 5-1 Accessing Endurance Manager Commands
To access...
All commands
Commands for a specific server
component
74
To execute command . . .
1. From the main dialog box menu, select Tools
This displays the Display and Control dialog box.
2. Select the command and any parameters.
3. Click Apply.
1. In the main dialog box, double click on the component for which you
want to execute a command. This displays only the commands that are
available for that component in a Display and Control dialog box.
2. Select the command and any parameters.
3. Click Apply.
Commands
page 181 for
Table
Display and Control.