Reconfiguring A Public Ethernet Adapter; Considerations For Configuring A Replacement Adapter - HP NetServer AA 4000 Administrator's Manual

Chapter 9
Table 9-2 Considerations for Configuring a Replacement Adapter
Characteristic IL Adapter
Speed Per adapter type
Duplex FULL or HALF
Media Type Per the specifications for the
adapter

Reconfiguring a Public Ethernet Adapter

After you replace and configure a Ethernet adapter that serviced a public network, you must
update the server configuration to include the new adapter's MAC address.
To update the configuration:
Step Action
1 Schedule an appropriate time to shut down
the server.
2 On IOP1, start the Endurance Configuration
Utility and complete the following:
• Save the configuration to a file on the
IOP system disk (as a backup
precaution).
• Select the network icon (for the
redundant adapter set) that includes the
adapter that you replaced
• Click Remove, and then Commit.
• Select the network icon, and click Add.
• When prompted, enter the Ethernet
address parameters for each network
adapter.
• Click Finish.
• Click Commit.
Public Network Adapter
Per Local Network requirements
Per Local Network requirements
Per Local Network requirements
Notes
At that time, follow the instructions in
Down the CE Operating System
213.
After completing these steps on IOP1, repeat them
on IOP2, as noted in Step 4.
Maintenance
Shutting
section on page
231