Replacing The Il Cable - HP NetServer AA 4000 Administrator's Manual
Hp netserver aa 6200 solution release 3.0 administrator’s guide
Hide thumbs
Also See for NetServer AA 4000:
- Manual (386 pages) ,
- Reference manual (142 pages) ,
- Installation manual (82 pages)
Table of Contents
Advertisement
Chapter 9
Replacing the IL Cable
The IL (IOP Link) cable provides a direct Ethernet connection between the IOPs.
Caution: Before proceeding, make sure you are properly grounded using, for instance, a
wrist strap with an attached alligator clip that is connected to an appropriate
ground.
To replace an IL cable:
Step
Action
1
Obtain a replacement IL cable.
2
Decide which IOP can be removed with the
least impact to your system, and shut down
that IOP, as described on
3
Detach the IL cable from IOP1 and IOP2.
4
Install the new IL cable by attaching it to
IOP1 and IOP2.
5
Reboot the IOP that you shut down in Step
step
2.
6
Using Endurance Manager:
• Reenable any faulted or disabled
components
• Make sure that any components affected
by this procedure are active or online.
page
210.
(page
241).
Notes
Obtain the appropriate cable that meets the
specifications for your Ethernet adapter.
Maintenance
217
Advertisement
Table of Contents
