HP NetServer AA 4000 Administrator's Manual page 246

Chapter 9
Step Action
6 Using the Endurance Manager:
• Make sure that the Ethernet connection
attached to the replacement adapter is
active.
• Make sure that any components affected
by this procedure are active or online.
Reenable any faulted or disabled
components
7 If this adapter provides connectivity to a
public network:
• Confirm that the new Ethernet cable
operates properly:
- Establish a network connection to
validate that the connection is
operating properly.
- Issue an Endurance Manager Disable
IOPy.Ethernet command.
- Issue an Endurance Manager Enable
IOPy.Ethernet command for the
Ethernet connection disabled in the
previous step.
- Using the Endurance Manager main
window, confirm that the Ethernet
connection that uses the replacement
cable is active and primary (appears
bright green).
• Schedule an appropriate time to shut
down the server and to update the server
configuration.
8 Do not make any further network
configuration changes until you complete
the information in the
Public Ethernet Adapter
230
(page 241).
Reconfiguring a
section.
Notes
For example, use Windows NT Explorer to connect
to a network node. Copy some files to and from the
server during the following steps.
This disables the Ethernet connection that
maintained network connectivity while you
completed the previous steps.
If the Ethernet connection supported by the
replacement cable remains active and primary, the
cable that you replaced is fully operational.
Follow the instructions in
Ethernet Adapter on page
Maintenance
Reconfiguring a Public
231.