Table of Contents
Advertisement
7.
Install the component as described above.
Removing and replacing the intrusion switch cable
The intrusion switch screws face CPU 0.
1.
Power off the server
2.
Remove the access panel
3.
Remove the PCI riser cage
4.
Open the processor cage.
5.
Using a screwdriver, remove the switch.
1 18
Removal and replacement procedures
("Powering off the server" (page
("Removing and replacing the access panel" (page
("Removing and replacing the PCI riser cage" (page
94)).
99)).
104)).
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Carrier-Grade rx2800 i2 Server DC and is the answer not in the manual?