Iopn.monitor Show Initialization Interval - HP NetServer AA 4000 Administrator's Manual
Hp netserver aa 6200 solution release 3.0 administrator’s guide
Hide thumbs
Also See for NetServer AA 4000:
- Manual (386 pages) ,
- Reference manual (142 pages) ,
- Installation manual (82 pages)
Table of Contents
Advertisement
Chapter 5
IOPn.Monitor Show Initialization Interval
This command displays the initialization interval for the specified IOP. The initialization
interval is the time period in seconds that the IOP waits to initialize with the other IOP before
either or both of the following occur:
•
Responding to the CE if Auto Start is true (enabled).
•
An event is generated if the other IOP does not become available and if Auto Start is false
(disabled).
By default, Auto Start is disabled and the initialization interval is 120 seconds.
Command
IOPn.Monitor Show Initialization Interval
Console Syntax MTCCONS IOPn.Monitor Show Initialization Interval
n – the ID number of the IOP (1 or 2)
Variables
Results
For an example of the results of this command, refer to
Parameters.
See Also
IOPn.Monitor Set Initialization Interval
IOPn.Monitor Show Parameters
Commands
IOPn.Monitor Show
149
Advertisement
Table of Contents
