HP 6125G Configuration Manual page 37

Step
3. Enter AUX user interface
view.
4. Configure the baud rate.
5. Configure the parity check
mode.
6. Configure the number of stop
bits.
7. Configure the number of
data bits in a character.
8. Define a shortcut key for
enabling a terminal session.
9. Define a shortcut key for
terminating tasks.
10. Configure the flow control
mode.
11. Specify the terminal display.
12. Configure the user privilege
level for login users.
13. Set the maximum number of
lines to be displayed on a
screen.
Command
user-interface aux first-number
[ last-number ]
speed speed-value
parity { even | none | odd }
stopbits { 1 | 1.5 | 2 }
databits { 7 | 8 }
activation-key character
escape-key { default | character }
flow-control { hardware | none |
software }
terminal type { ansi | vt100 }
user privilege level level
screen-length screen-length
31
Remarks
N/A
By default, the transmission rate is
9600 bps.
The default setting is none, namely,
no parity check.
The default is 1.
Stop bits indicate the end of a
character. The more the stop bits, the
slower the transmission.
By default, the number of data bits in
each character is 8.
The setting depends on the character
coding type. For example, you can
set it to 7 if standard ASCII
characters are to be sent, and set it
to 8 if extended ASCII characters
are to be sent.
By default, press Enter to enable a
terminal session.
By default, press Ctrl+C to terminate
a task.
By default, the flow control mode is
none.
The device supports only the none
mode.
By default, the terminal display type
is ANSI.
The device supports two terminal
display types: ANSI and VT100. HP
recommends setting the display type
to VT100 for both the device and the
client. If the device and the client use
different display types or both use
the ANSI display type, when the
total number of characters of a
command line exceeds 80, the
screen display on the terminal might
be abnormal. For example, the
cursor might be displayed at a
wrong place.
By default, the default command
level is 3 for AUX user interfaces.
By default, a screen displays 24
lines at most.
A value of 0 disables pausing
between screens of output.