Changing The Level Of A Command; Saving The Running Configuration - HP 6125G Configuration Manual

User interface
authentication
mode
scheme

Changing the level of a command

Every command in a view has a default command level. The default command level scheme is sufficient
for the security and ease of maintenance requirements of most networks. If you want to change the level
of a command, make sure the change does not result in any security risk or maintenance problem.
To change the level of a command:
Step
1. Enter system view.
2. Change the level of a
command in a specific view.

Saving the running configuration

You can use the save command in any view to save all submitted and executed commands into the
configuration file. Commands saved in the configuration file can survive a reboot. The save command
does not take effect on one-time commands, including display and reset commands. One-time
commands are never saved.
User privilege level
switching
authentication mode
local
local scheme
scheme
scheme local
Command
system-view
command-privilege level level view
view command
Information required for
the first authentication
mode
Password configured on the
device with the super
password command for the
privilege level.
Password configured on the
device with the super
password command for the
privilege level.
Password for privilege level
switching that is configured
on the AAA server. The
system uses the username
used for logging in as the
privilege level switching
username.
Password for privilege level
switching that is configured
on the AAA server. The
system uses the username
used for logging in as the
privilege level switching
username.
19
Information required for the
second authentication mode
N/A
Password for privilege level
switching that is configured on
the AAA server. The system uses
the username used for logging in
as the privilege level switching
username.
N/A
Password configured on the
device with the super password
command for the privilege level.
Remarks
N/A
See Table 7 for the default settings.