HP 6125G Configuration Manual page 89

Figure 39 Network diagram
Configuration procedure
This configuration procedure assumes that the PC and the IRF fabric can reach each other.
Configure the PC (TFTP server):
1.
Enable the TFTP server. (Details not shown.)
Configure a TFTP working directory. (Details not shown.)
Configure the IRF fabric (TFTP client):
2.
# Examine the storage medium of the device for insufficiency or impairment. If no sufficient free
space is available, use the delete/unreserved file-url command to delete unused files. (Details not
shown.)
# Download system software image file newest.bin from the PC to the master and subordinate
devices:
Download system software image file newest.bin from the PC to the root directory of the Flash
on the master.
<Sysname> tftp 1.2.1.1 get newest.bin
Download system software image file newest.bin from the PC to the root directory of the Flash
on a subordinate device (with the member ID 2).
<Sysname> tftp 1.2.1.1 get newest.bin slot2#flash:/newest.bin
# Upload a configuration file config.cfg to the TFTP server.
<Sysname> tftp 1.2.1.1 put config.cfg configback.cfg
# Specify newest.bin as the main system software image file for the next startup for all member
devices.
<Sysname> boot-loader file newest.bin slot all main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on slot
1!
The specified file will be used as the main boot file at the next reboot on slot
2!
IMPORTANT:
The system software image file used for the next startup must be saved in the Flash root directory. You can
copy or move a file to the Flash root directory.
# Reboot the IRF fabric and the software is upgraded.
<Sysname> reboot
83