Download  Print this page

Specifying A Configuration File For The Next Startup; Backing Up The Next-startup Configuration File To A Tftp Server; Deleting The Next-startup Configuration File - HP 6125G Configuration Manual

Fundamentals configuration guide.
Hide thumbs

Advertisement

Specifying a configuration file for the next startup

You can specify a .cfg configuration file as the main startup configuration file to be used at the next
startup when you use the save command to save the running configuration to it.
Alternatively, perform the following task in user view to specify the next-startup configuration file:
Task
Specify the next-startup
configuration file.
Backing up the next-startup configuration file to a
TFTP server
Before performing this task, make sure the server is reachable and enabled with TFTP service, and you
have read and write permissions.
This task backs up only the main next-startup configuration file.
To back up the next-startup configuration file to a TFTP server:
Step
1.
Verify that a next-startup
configuration file has been
specified in user view.
2.
Back up the next-startup
configuration file to a TFTP
server in user view.

Deleting the next-startup configuration file

CAUTION:
This task permanently deletes the next-startup configuration file from all member devices. Before
performing this task, back up the file as needed.
Command
startup saved-configuration cfgfile
[ backup | main ]
Command
display startup
backup startup-configuration to
dest-addr [dest-filename ]
97
Remarks
The setting applies to all member
devices.
IMPORTANT:
The configuration file must use
the .cfg extension and be saved in
the root directory of storage media.
If the storage media has been
partitioned, save the file on the first
partition.
Remarks
Optional.
If no next-startup configuration file
has been specified, the back
operation will fail.
N/A

Advertisement

Table of Contents

   Related Manuals for HP 6125G

This manual is also suitable for:

5500 hi series6125 blade switch series

Comments to this Manuals

Symbols: 0
Latest comments: