Ethernet Oam Configuration Example - HP 6125G Configuration Manual

Task
Display the information about an
Ethernet OAM connection.
Clear statistics on Ethernet OAM
packets and Ethernet OAM link
error events.

Ethernet OAM configuration example

Network requirements
On the network shown in
Enable Ethernet OAM on Device A and Device B to auto-detect link errors between the two devices
•
Monitor the performance of the link between Device A and Device B by collecting statistics about
•
the error frames received by Device A
Figure 2 Network diagram
Configuration procedure
Configure Device A:
1.
# Configure GigabitEthernet 1/0/1 to operate in passive Ethernet OAM mode and enable
Ethernet OAM for it.
<DeviceA> system-view
[DeviceA] interface gigabitethernet 1/0/1
[DeviceA-GigabitEthernet1/0/1] oam mode passive
[DeviceA-GigabitEthernet1/0/1] oam enable
[DeviceA-GigabitEthernet1/0/1] quit
# Set the errored frame detection interval to 20 seconds and set the errored frame event triggering
threshold to 10.
[DeviceA] oam errored-frame period 20
[DeviceA] oam errored-frame threshold 10
Configure Device B:
2.
# Configure GigabitEthernet 1/0/1 to operate in active Ethernet OAM mode (the default) and
enable Ethernet OAM for it.
<DeviceB> system-view
[DeviceB] interface gigabitethernet 1/0/1
[DeviceA-GigabitEthernet1/0/1] oam mode active
[DeviceB-GigabitEthernet1/0/1] oam enable
[DeviceB-GigabitEthernet1/0/1] quit
Verify the configuration:
3.
Command
display oam { local | remote }
[ interface interface-type
interface-number ] [ | { begin |
exclude | include }
regular-expression ]
reset oam [ interface interface-type
interface-number ]
Figure 2, perform the following operations:
13
Remarks
Available in any view
Available in user view