Configuration Procedure - HP 6125G Configuration Manual

Figure 6 Network diagram

Configuration procedure

Configure a VLAN and assign ports to it:
1.
On each device shown in
through GigabitEthernet 1/0/4 to VLAN 100.
Enable CFD:
2.
# Enable CFD on Device A.
<DeviceA> system-view
[DeviceA] cfd enable
Enable CFD on Device B through Device E using the same method.
Configure service instances:
3.
# Create MD_A (level 5) on Device A, create MA_A, which serves VLAN 100, in MD_A, and
create service instance 1 for MD_A and MA_A.
[DeviceA] cfd md MD_A level 5
[DeviceA] cfd ma MA_A md MD_A vlan 100
[DeviceA] cfd service-instance 1 md MD_A ma MA_A
Configure Device E as you configure Device A.
# Create MD_A (level 5) on Device B, create MA_A that serves VLAN 100, in MD_A, and then
create service instance 1 for MD_A and MA_A. In addition, create MD_B (level 3) and MA_B that
serves VLAN 100, in MD_B, and then create service instance 2 for MD_B and MA_B.
[DeviceB] cfd md MD_A level 5
[DeviceB] cfd ma MA_A md MD_A vlan 100
[DeviceB] cfd service-instance 1 md MD_A ma MA_A
[DeviceB] cfd md MD_B level 3
[DeviceB] cfd ma MA_B md MD_B vlan 100
[DeviceB] cfd service-instance 2 md MD_B ma MA_B
Configure Device D in the same way as Device B.
# Create MD_B (level 3) on Device C, create MA_B that serves VLAN 100, in MD_B, and then
create service instance 2 for MD_B and MA_B.
[DeviceC] cfd md MD_B level 3
Figure 6, create VLAN 100 and assign ports GigabitEthernet 1/0/1
25