Intersecting Ring Configuration Example - HP 6125G Configuration Manual

[DeviceB-rrpp-domain1] quit
# Enable RRPP.
[DeviceB] rrpp enable
Configure Device C:
3.
The configuration on Device C is similar to that on Device B and is not shown here.
Configure Device D:
4.
The configuration on Device D is similar to that on Device B and is not shown here.
Verify the configuration:
5.
Use the display command to view RRPP configuration and operational information on each device.

Intersecting ring configuration example

Networking requirements
As shown in
• Device A, Device B, Device C, Device D, and Device E form RRPP domain 1. VLAN 4092 is the
primary control VLAN of RRPP domain 1, and RRPP domain 1 protects VLANs 1 through 30.
Device A, Device B, Device C, and Device D form primary ring 1, and Device B, Device C and
•
Device E form subring 2.
• Device A is the master node of primary ring 1, with GigabitEthernet 1/0/1 as the primary port and
GigabitEthernet 1/0/2 the secondary port.
Device E is the master node of subring 2, with GigabitEthernet 1/0/1 as the primary port and
•
GigabitEthernet 1/0/2 the secondary port.
Device B is the transit node of primary ring 1 and the edge node of subring 2, and GigabitEthernet
•
1/0/3 is the edge port.
• Device C is the transit node of primary ring 1 and the assistant-edge node of subring 1, and
GigabitEthernet 1/0/3 is the edge port.
Device D is the transit node of primary ring 1, with GigabitEthernet 1/0/1 as the primary port and
•
GigabitEthernet 1/0/2 the secondary port.
Figure 19 Network diagram
Figure 19,
65