HP 6125G Configuration Manual page 204

# Create track entry 1 to be associated with the BFD session to check whether the uplink device
with the IP address 1.1.1.2 is reachable.
[SwitchA] track 1 bfd echo interface vlan-interface 3 remote ip 1.1.1.2 local ip
1.1.1.1
Configure VRRP on Switch A:
4.
# Create VRRP group 1, and configure the virtual IP address of the group as 192.168.0.10.
Configure the priority of Switch A in VRRP group 1 as 110. Configure VRRP group 1 to monitor the
status of track entry 1. When the status of the track entry becomes Negative, the priority of Switch
A decreases by 20.
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] vrrp vrid 1 virtual-ip 192.168.0.10
[SwitchA-Vlan-interface2] vrrp vrid 1 priority 110
[SwitchA-Vlan-interface2] vrrp vrid 1 track 1 reduced 20
[SwitchA-Vlan-interface2] return
Configure VRRP on Switch B:
5.
# Create VRRP group 1, and configure the virtual IP address of the group as 192.168.0.10.
<SwitchB> system-view
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] vrrp vrid 1 virtual-ip 192.168.0.10
[SwitchB-Vlan-interface2] return
Verify the configuration:
6.
# Display the detailed information about the VRRP group on Switch A.
<SwitchA> display vrrp verbose
IPv4 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 1
Interface Vlan-interface2
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
VRRP Track Information:
Track Object
# Display the information about track entry 1 on Switch A.
<SwitchA> display track 1
Track ID: 1
Status: Positive
Duration: 0 days 0 hours 0 minutes 32 seconds
Notification delay: Positive 0, Negative 0 (in seconds)
Reference object:
BFD session:
Packet type: Echo
: Standard
: Virtual MAC
: 1 Adver Timer
: Up State
: 110 Running Pri
: Yes Delay Time
: None
: 192.168.0.10
: 0000-5e00-0101
: 192.168.0.101
: 1 State : Positive
197
: 1
: Master
: 110
: 0
Pri Reduced : 20