HP 6125G Configuration Manual page 215

Figure 54 Network diagram
Configuration procedure
Create VLANs, and assign corresponding ports to the VLANs. Configure the IP address of each
1.
VLAN interface as shown in
Configure a track entry on Switch A:
2.
# Configure track entry 1, and associate it with the physical status of the uplink interface
VLAN-interface 3.
[SwitchA] track 1 interface vlan-interface 3
Configure VRRP on Switch A:
3.
# Create VRRP group 1, and configure the virtual IP address 10.1.1.10 for the group.
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.10
# Set the priority of Switch A in VRRP group 1 to 110.
[SwitchA-Vlan-interface2] vrrp vrid 1 priority 110
# Configure to monitor track entry 1, and specify the priority decrement as 30.
[SwitchA-Vlan-interface2] vrrp vrid 1 track 1 reduced 30
Configure VRRP on Switch B:
4.
<SwitchB> system-view
[SwitchB] interface vlan-interface 2
# Create VRRP group 1, and configure the virtual IP address 10.1.1.10 for the group.
[SwitchB-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.10
Verify the configuration:
5.
After configuration, ping Host B on Host A, and you can see that Host B is reachable. Use the
display vrrp command to view the configuration result.
# Display detailed information about VRRP group 1 on Switch A.
[SwitchA-Vlan-interface2] display vrrp verbose
IPv4 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 1
Interface Vlan-interface2
Figure 54. (Details not shown.)
: Standard
: Virtual MAC
208