Packet Types; Configuring Vrrp For Ipv4; Vrrp For Ipv4 Configuration Task List - HP 6125G Configuration Manual

Timeout Timer—The duration that the new AVF takes over the VF owner. Before this timer times out,
•
all the routers in the VRRP group keep the failed AVF, and the new AVF forwards the packets
destined for the virtual MAC address corresponding to the failed AVF. When this timer times out, all
the routers in the VRRP group remove the failed AVF, and the new AVF stops forwarding the packets
destined for the virtual MAC address corresponding to the failed AVF.
VF tracking
The AVF forwards packets destined to the MAC address of the AVF. If the uplink of the AVF fails and no
LVF is notified to take over the AVF's work, hosts (on the LAN) that use the MAC address of the AVF as
their gateway MAC address cannot access the external network.
This problem can be solved by the VF tracking function. You can monitor the uplink state by using
network quality analyzer (NQA) and bidirectional forwarding detection (BFD), and establish the
collaboration between the VF and the NQA or between the VF and the BFD through the tracking function.
When the uplink fails, the state of the monitored track entry changes to negative and the weight of the
VF decreases by a specified value. Then, the VF with a higher priority becomes the AVF and forwards
packets.
The VF tracking function can also work on an LVF to monitor its corresponding AVF on another router.
When the AVF fails, the LVF immediately takes over the AVF to ensure uninterrupted network
communications.

Packet types

VRRP standard protocol mode defines only VRRP advertisement. Only the master in a VRRP group
periodically sends VRRP advertisements, and the backups do not send VRRP advertisements.
VRRP load balancing mode defines the following types of packets:
• Advertisement—VRRP advertises VRRP group state and information about the VF that is in the active
state. Both the master and the backups periodically send VRRP advertisements.
Request—If a backup is not the VF owner, it sends a request to ask the master to assign a virtual
•
MAC address.
Reply—When receiving a request, the master sends a reply to the backup router to assign a virtual
•
MAC address. After receiving the reply, the backup router creates a VF that corresponds to the
virtual MAC address, and then becomes the owner of this VF.
Release—When a VF owner fails, the router that takes over its responsibility sends a release after
•
a specified period of time to notify the other routers in the VRRP group to delete the VF of the failed
VF owner.
NOTE:
The format of these packets is similar to that of the advertisement in VRRP standard protocol mode except
that a packet used in load balancing mode is appended with option field, which contains information for
load balancing.

Configuring VRRP for IPv4

VRRP for IPv4 configuration task list

To form a VRRP group, perform the following configurations on each device in the VRRP group.
123