HP 6125G Configuration Manual page 51

[DeviceA-GigabitEthernet1/1/4] duplex full
[DeviceA-GigabitEthernet1/1/4] speed 1000
[DeviceA-GigabitEthernet1/1/4] dldp enable
[DeviceA-GigabitEthernet1/1/4] quit
# Set the DLDP mode to enhanced.
[DeviceA] dldp work-mode enhance
# Set the port shutdown mode to manual.
[DeviceA] dldp unidirectional-shutdown manual
Configure Device B:
2.
# Enable DLDP globally.
<DeviceB> system-view
[DeviceB] dldp enable
# Configure GigabitEthernet 1/1/3 to operate in full duplex mode and at 1000 Mbps, and
enable DLDP on it.
[DeviceB] interface gigabitethernet 1/1/3
[DeviceB-GigabitEthernet1/1/3] duplex full
[DeviceB-GigabitEthernet1/1/3] speed 1000
[DeviceB-GigabitEthernet1/1/3] dldp enable
[DeviceB-GigabitEthernet1/1/3] quit
# Configure GigabitEthernet 1/1/4 to operate in full duplex mode and at 1000 Mbps, and
enable DLDP on it.
[DeviceB] interface gigabitethernet 1/1/4
[DeviceB-GigabitEthernet1/1/4] duplex full
[DeviceB-GigabitEthernet1/1/4] speed 1000
[DeviceB-GigabitEthernet1/1/4] dldp enable
[DeviceB-GigabitEthernet1/1/4] quit
# Set the DLDP mode to enhanced.
[DeviceB] dldp work-mode enhance
# Set the port shutdown mode to manual.
[DeviceB] dldp unidirectional-shutdown manual
Verify the configuration:
3.
After the configurations are complete, you can use the display dldp command to display the DLDP
configuration information on ports.
# Display the DLDP configuration information on all the DLDP-enabled ports of Device A.
[DeviceA] display dldp
DLDP global status : enable
DLDP interval : 5s
DLDP work-mode : enhance
DLDP authentication-mode : none
DLDP unidirectional-shutdown : manual
DLDP delaydown-timer : 1s
The number of enabled ports is 2.
Interface GigabitEthernet1/1/3
DLDP port state : advertisement
DLDP link state : up
44