Configuring Vrrp; Vrrp Overview - HP 6125G Configuration Manual

High availability configuration guide
Hide thumbs Also See for 6125G:
Table of Contents

Advertisement

Configuring VRRP

The term router in this document refers to both routers and Layer 3 switches.
The term interface in the VRRP feature refers to VLAN interfaces.

VRRP overview

Typically, as shown in
every host on a network segment. All packets destined to other network segments are sent over the
default route to the gateway, which then forwards the packets. However, when the gateway fails, all the
hosts that use the gateway as the default next-hop router fail to communicate with external networks.
Figure 27 LAN networking
Configuring a default route for network hosts facilitates your configuration, but also requires high
performance stability of the device that acts as the gateway. Using more egress gateways is a common
way to improve system reliability, but introduces the problem of routing among the egresses.
Virtual Router Redundancy Protocol (VRRP) is designed to address this problem. VRRP adds a group of
routers that can act as network gateways to a VRRP group, which forms a virtual router. Routers in the
VRRP group elect a master through the VRRP election mechanism to act as a gateway, and hosts on a
LAN only need to configure the virtual router as their default network gateway.
VRRP is an error-tolerant protocol, which improves the network reliability and simplifies configurations on
hosts. On a multicast and broadcast LAN such as Ethernet, VRRP provides highly reliable default links
without configuration changes (such as dynamic routing protocols, route discovery protocols) when a
router fails, and prevent network interruption because of a single link failure.
VRRP operates in either of the following modes:
Standard protocol mode—Includes two versions VRRPv2 and VRRPv3 based on RFCs. VRRPv2 is
based on IPv4, and VRRPv3 is based on IPv6. The two versions implement the same functions but
are applied in different network environments. For more information, see
mode."
Figure
27, you can configure a default route with the gateway as the next hop for
112
"VRRP standard protocol

Advertisement

Table of Contents
loading

This manual is also suitable for:

6125 blade switch series

Table of Contents