Smart Link Configuration Examples; Single Smart Link Group Configuration Example - HP 6125G Configuration Manual

Task
Clear the statistics about flush
messages.

Smart Link configuration examples

Single smart link group configuration example

Network requirements
As shown in
Device E are associated devices. Traffic of VLANs 1 through 30 on Device C and Device D are dually
uplinked to Device A.
Configure Smart Link on Device C and Device D for dual uplink backup.
Figure 23 Network diagram
Configuration procedure
Configure Device C:
1.
# Create VLANs 1 through 30, map these VLANs to MSTI 1, and activate the MST region
configuration.
<DeviceC> system-view
[DeviceC] vlan 1 to 30
[DeviceC] stp region-configuration
[DeviceC-mst-region] instance 1 vlan 1 to 30
[DeviceC-mst-region] active region-configuration
[DeviceC-mst-region] quit
# Shut down GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2, disable the spanning tree
feature on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 separately, configure them as
trunk ports, and assign them to VLANs 1 through 30.
[DeviceC] interface gigabitethernet 1/0/1
[DeviceC-GigabitEthernet1/0/1] shutdown
Figure 23, Device C and Device D are smart link devices, and Device A, Device B, and
Command
reset smart-link statistics
97
Remarks
Available in user view