HP 6125G Configuration Manual page 198

High availability configuration guide
Hide thumbs Also See for 6125G:
Table of Contents

Advertisement

# Set the authentication mode of VRRP group 1 to simple, and the authentication key to hello.
[SwitchA-Vlan-interface2] vrrp vrid 1 authentication-mode simple hello
# Configure the master to send VRRP packets at an interval of five seconds.
[SwitchA-Vlan-interface2] vrrp vrid 1 timer advertise 5
# Configure Switch A to operate in preemptive mode, and set the preemption delay to five
seconds.
[SwitchA-Vlan-interface2] vrrp vrid 1 preempt-mode timer delay 5
# Configure to monitor track entry 1, and specify the priority decrement to 30.
[SwitchA-Vlan-interface2] vrrp vrid 1 track 1 reduced 30
Configure VRRP on Switch B:
5.
<SwitchB> system-view
[SwitchB] interface vlan-interface 2
# Create VRRP group 1, and configure the virtual IP address 10.1.1.10 for the group.
[SwitchB-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.10
# Set the authentication mode of VRRP group 1 to simple, and the authentication key to hello.
[SwitchB-Vlan-interface2] vrrp vrid 1 authentication-mode simple hello
# Configure the master to send VRRP packets at an interval of five seconds.
[SwitchB-Vlan-interface2] vrrp vrid 1 timer advertise 5
# Configure Switch B to operate in preemptive mode, and set the preemption delay to five
seconds.
[SwitchB-Vlan-interface2] vrrp vrid 1 preempt-mode timer delay 5
Verify the configuration:
6.
After configuration, ping Host B on Host A, and you can see that Host B is reachable. Use the
display vrrp command to view the configuration result.
# Display detailed information about VRRP group 1 on Switch A.
[SwitchA-Vlan-interface2] display vrrp verbose
IPv4 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 1
Interface Vlan-interface2
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
VRRP Track Information:
Track Object
# Display detailed information about VRRP group 1 on Switch B.
[SwitchB-Vlan-interface2] display vrrp verbose
IPv4 Standby Information:
Run Mode
Run Method
: Standard
: Virtual MAC
: 1
Adver Timer
: Up
State
: 110
Running Pri
: Yes
Delay Time
: Simple
Key
: 10.1.1.10
: 0000-5e00-0101
: 10.1.1.1
: 1
State : Positive
: Standard
: Virtual MAC
191
: 5
: Master
: 110
: 5
: ******
Pri Reduced : 30

Advertisement

Table of Contents
loading

This manual is also suitable for:

6125 blade switch series

Table of Contents