Changing The Ramp Starting Pressure; Changing The Led Backlight Setting - Respironics BiPAP autoSV Advanced User Manual

24
6.2.2.3 C R
HANGING THE AMP
Th e device is equipped with an optional ramp feature. Th is feature will reduce the pressure and then
gradually increase (ramp) the pressure to the prescription pressure setting so you can fall asleep more
comfortably.
Th e ramp feature is not prescribed for all users. If the screen shown in Figure 6–10 does not appear on your
display, you cannot adjust this setting.
To change the ramp starting pressure setting, complete the following steps:
1. From either the Monitoring or Standby screens, press the Right User button until the Ramp Start
Setting screen appears, as shown in Figure 6–10.
2. Press the or RAMP
HEAT
adjust the setting from 4 cm H
6.2.2.4 C LED B
HANGING THE
When airfl ow is turned on and the device is in the Operate state, you can turn the control pad lighting
behind the buttons on or off using the LED backlight setting.
NOTE: Th e lights are always on when the airfl ow is off and the device is in Standby.
To change the LED backlight setting, complete the following steps:
1. From either the Monitoring or Standby screens, press the Right User button until the LED Backlight
Setting screen appears, as shown in Figure 6–11.
2. Press the or
RAMP
HEAT
means the light is off .
S P
TARTING RESSURE
Figure 6–10 Ramp Start Setting Screen
button to increase or decrease the ramp starting pressure as needed. You can
O to the current Min EPAP pressure setting.
2
S
ACKLIGHT ETTING
Figure 6–11 LED Backlight Setting Screen
button to select a new setting. A setting of 1 means the light is on, while 0
User Manual