Using The Ramp Feature - Respironics REMstar M Series User Manual

The Active Display screen shows the prescribed or ramping pressure. If the ramp feature is
enabled by your health care provider, the Ramp symbol also appears as described below:
s
yMbol
4. Put on your mask assembly when the air starts to flow.
5. Make sure that no air is leaking from your mask into your eyes. If it is, adjust the mask and
headgear until the air leak stops. See the instructions provided with your mask for more
information.
Note: A small amount of mask leak is normal and acceptable. Correct large mask
leaks or eye irritation from an air leak as soon as possible.
6. If you are using the device while sleeping, try placing the tubing from the device over your
headboard. This may reduce tension on the mask.
Note:
If you are having trouble with your mask, refer to the instructions supplied with
the mask.
4.2 U
sing thE
The optional Ramp feature can be enabled or disabled by your home care provider.
This feature reduces the air pressure when you are trying to fall asleep. Then it gradually increases
(ramps) the pressure until your prescription setting is reached, allowing you to fall asleep more
comfortably.
If ramp is enabled on your device, after you turn on the airflow, press the Ramp button
the top of the device. You can use the Ramp button as often as you wish during the night.
Note: If the ramp feature is disabled, nothing will happen when you press the Ramp
button.
4-2
If the Ramp feature is enabled, you can initiate it by pressing the Ramp
button. When the ramp function is active, the Ramp symbol displays on
the Active Display screen, as shown above.
R f
aMp EatURE
d
EsCRiption
REM M s
staR ERiEs
on
U M
sER anUal