Operating Modes; Freerun Mode - IDS uEye series User Manual

User Manual uEye Cameras V3.32
6.1

Operating Modes

6.1.1

Freerun Mode

In freerun mode, the camera sensor captures one image after another at the set frame rate.
Exposure and readout/transfer of the image data are performed in parallel. This allows the maximum
camera frame rate to be achieved. The frame rate and the exposure time can be set separately. The
captured images can be transferred one by one or continuously to the PC.
If trigger mode is active, you need to disable it before activating freerun mode.
· Single frame mode (snap mode)
The next image exposed by the sensor will be transferred. You cannot use the uEye flash outputs
in this mode.
· Continuous mode (live mode)
Images are captured and transferred continuously. You can use the uEye flash outputs.
)
* Optional function. The start time and duration of the flash signal are defined by the Flash delay and
Duration parameters (see also Camera Settings: I/O).
24
The following illustrations show a schematic view of the image capture sequence. The
sensor exposure and readout times and the transmission times depend on the camera
settings. The pre-processing time depends on the API functions you are using (e.g. color
conversion, edge enhancement).
Figure 21: Freerun mode (live mode)
Figure 22: Freerun mode (snap mode)
© 2009 IDS Imaging Development Systems GmbH