IDS uEye series User Manual page 163

9.2.2 Dimensions
Figure 131: USB uEye RE
Lens mount
C-mount
Differences to the USB uEye SE
The uEye RE features the following modifications compared to the standard
USB
models:
· Binders series 712 is used for the connector. This series is approved for the IP 65 and IP 67
standards.
· The housing parts are sealed against each other with O-rings:
§
Rear panel/centerpiece
§
Centerpiece/front panel
§
Front panel/tube
The LED light conductor is bonded.
·
Tubes in different lengths are optionally available for sealing the lens.
·
· M3 and M5 mounting options are provided on the housing.
© 2009 IDS Imaging Development Systems GmbH
Enclosure protection class
IP 65/IP 67
For the dimensions of the USB uEye RE accessories, please refer to the USB uEye RE
Accessories chapter.
The USB uEye RE housing variant is IP 65/67 compliant. The following requirements must
be met for compliance with the IP 65/67 standards:
· Cables must be attached to both connectors (USB and trigger) during operation. If the
trigger connector is not used, it must be closed with the cover.
· A tube must be connected.
Attention: The USB uEye RE has not been approved for underwater use.
Weight
Camera without tube
Tube
9 Specifications
145 g (CMOS), 180 g (CCD)
max. 70 g
uEye SE
USB
163