IDS uEye series User Manual page 197

Pin Assignment of the I/O Connector
Figure 182: USB uEye LE - Pin assignment of the I/O
connector (b oard-level version only)
Pin
1 5 V
2 Trig
3 3V3
4 GPIO 1 Programmable input/output (General Purpose I/O) 1
5 SCL
6 SDA
7 GPIO 2 Programmable input/output (General Purpose I/O) 2
8 GND
9 Flash Digital output
10 GND
*1) This voltage depends on the supply voltage required for the sensor used (see tab le b elow)
© 2009 IDS Imaging Development Systems GmbH
Description
USB power supply (VCC) 5 V
Max. admissible current = 500 mA
Current consumption of the LE camera itself: 300...350 mA.
Digital input
Power supply of the internal voltage transformer
Supply voltage 3.3 V or 3.0 V
Max. admissible current 230 mA (3.3 V) or 250 mA (3.0 V)
I2C bus clock signal
Supply voltage 3.3 V or 3.0 V
I2C bus data signal
Supply voltage 3.3 V or 3.0 V
USB ground (GND)
USB ground (GND)
The I/O connector of the uEye LE can be provided with a 2 x 5-pin connecting plug with a
2.54 mm (0.1") lead spacing.
IDS shall not be liable for any damage to the camera or connected devices arising from
installation of the connecting plug.
*1)
*1)
*1)
9 Specifications
197