1 Preface 1.1 Introduction IDS Imaging Development Systems GmbH has taken every possible care in preparing this manual. We however assume no liability for the content, completeness or quality of the information contained therein. The content of this manual is regularly updated and adapted to reflect the current status of the software. We furthermore do not guarantee that this product will function without errors, even if the stated specifications are adhered to.
The installation, inspection, maintenance, extension, and repair may only be done by authorized personnel. · The IDS NXT vision app-based sensor must be installed in such way that the specifications are met which are described in the manual. ·...
Setup: IDS NXT vegas IP protection class for your product. The use under ambient conditions different from those specified in this manual may result in damage of the product. · Do not subject this product to direct sunlight, moisture or shock.
5 Mounting and alignment Mount the IDS NXT vegas in the slot profiles on the rear of the device using the slot nuts supplied and appropriate M4 screws. To ensure optimum heat dissipation, the IDS NXT vegas should be fitted on a mount with good thermal conductivity.
2: Ethernet connector pin assignment (M12, 8-pin) After connecting the power supply, a progress bar for the boot process can be seen in the display. If the IDS NXT vegas has been booted successfully, the display shows a screen with status information (temperature, CPU utilization, and device date).
Setup: IDS NXT vegas 7.1 Pin assignment I/O connector 12-pin M12 connector (Attend 216A-12MSR) Signal Description VBUS Power supply, 12-24 V DC +20 % VBUS GND Reference level (ground) for power supply and RS-232 Opto IN (0) Trigger input with optocoupler...
8 IDS NXT vegas display You can use the display to obtain various status information for the IDS NXT vegas. In normal operation, the display is switched off after 10 seconds. Briefly press the button to activate the display and to move through the subsequent screens.
If your client PC is also in the link-local address range for this IPv4 network, you can establish a network connection to the IDS NXT vision app-based sensor for the initial setup. If there is no network cable connection or no compatible remote station, “No connection”...
· Windows: either via the icon on the desktop or under "Start > All prgrams > IDS > NXT > IDS NXT Cockpit". After launching, you will be in the “Device overview”. IDS NXT Cockpit scans the network for IDS NXT vision app- based sensors and lists them in this overview.
9.5 Network configuration in IDS NXT Cockpit After logging onto a IDS NXT vision app-based sensor you will see the “Dashboard”, which displays a range of device information. To set the network parameters select the network settings dialog (“Network”) under “Configuration”.
Page 13
Setup: IDS NXT vegas IDS NXT Cockpit netw ork configuration · Activate the “DHCP” switch to get an IP address (IPv4) for the device from a DHCP server. · Without DHCP you can assign the device static IP settings. September 2018...
Need help?
Do you have a question about the NXT vegas and is the answer not in the manual?
Questions and answers