Table of Contents
Advertisement
6
Warning Labels
Below are representative warning labels and their location on the UPS.
Hot surface.
Contact may result in burn injury.
Make sure all the warning labels are installed in the appropriate locations.
Allow equipment to cool before
If a label is missing or illegible, contact Toshiba Customer Support Center or an
servicing.
authorized representative.
A
DANGER
HAZARDOUS VOLTAGES
Hazardous voltages are used in the operation
of this equipment and could cause severe personal
injury or loss of life.
The following precautions should be observed to
reduce the risk of injury or death.
Only qualified technicians familiar with this equipment and the
information supplied with it should be permitted to install and
operate this equipment.
Installation of electrical equipment must be done in
accordance with National Electrical Code and any other state
or local codes. Proper grounding and conductor sizing must
be installed for safe operation.
During operation, keep all covers in place and cabinet
doors shut.
When performing visual inspections and maintenance, if
possible, be sure the UPS is turned off and the incoming
AC feed is turned off and locked out.
The UPS and Battery Cabinet will have hazardous
voltages pr esent even after the AC feed is turned off.
If it is necessary to make measurements with the power
on, do not touch any electrical connection points. Remove
all jewelry from wrists and fingers. Make sure test equipment
is in good, safe operating condition.
While servicing, stand on some type of insulation, and be
sure not to be grounded.
Follow the safety instructions given in the equipment manual
carefully and observe all danger, warning and caution notices.
12
MATERIAL - VINYL OR POLYESTER
TEMPERATURE - MINUS 20 TO 100 deg. C
ADHESIVE - V23 OR EQUIV.
MUST RESIST OIL SOLVENTS
ALL MATERIALS USED MUST
BE UL RECOGNIZED
C A U T I O N
WARNING AREA BACKGROUND COLOR: ANSI DANGER RED
WARNING AREA TEXT COLOR: ANSI WHITE
NOTICE
TEXT AREA BACKGROUND COLOR: ANSI WHITE
MATERIAL - VINYL OR POLYESTER
TEXT AREA TEXT COLOR: ANSI BLACK
TEMPERATURE - MINUS 20 TO 100 deg. C
CORNER RADUIS: VENDOR STANDARD
ADHESIVE - V23 OR EQUIV.
MUST RESIST OIL SOLVENTS
ALL MATERIALS USED MUST
BE UL RECOGNIZED
WARNING AREA BACKGROUND COLOR: ANSI WARNING ORANGE
WARNING AREA TEXT COLOR: ANSI BLACK
TEXT AREA BACKGROUND COLOR: ANSI WHITE
TEXT AREA TEXT COLOR: ANSI BLACK
CORNER RADIUS: VENDOR STANDARD
WARNING
AREA
TEXT AREA
40308
FIGURE 6.1 – 50 KVA UPS WARNING LABELS
DRAWN:
JK 10-4-93
THIS MATERIAL IS THE EXCLUSIVE PROPERTY OF TOSHIBA INTERNATIONAL
CORPORATION AND SHALL NOT BE REPRODUCED, USED, OR DISCLOSED
TO OTHERS UNLESS PRIOR WRITTEN AUTHORIZATION IS OBTAINED.
ECN
DATE
BY
ECN
DATE
BY
13131 WEST LITTLE YORK ROAD, HOUSTON, TX 77041 U.S.A.
PN 40832
B
DANGER
RISK OF ELECTRIC SHOCK
Capacitors stay charged after power
has been shut off.
Accidental contact with live parts can
cause personal injury and death.
Turn off and lock out all power sources.
Wait at least five (5) minutes for power
to dissipate then check voltage before
servicing.
C
3.00"
WA R N I N G
CRITICAL FUSE SIZING
Incorrect fuse replacement size
may result in fire or inadequate
equipment protection.
1.00"
Replace only with same type
and rating of fuse.
D
40° AMBIENT
TEMPERATURE
CHECKED:
APPROVED:
DRAWN:
CHECKED:
APPROVED:
TF 10-15-04 TF 10-15-04
VB 3-28-94
TF 10-24-02 TF 10-24-02
THIS MATERIAL IS THE EXCLUSIVE PROPERTY OF TOSHIBA INTERNATIONAL
CORPORATION AND SHALL NOT BE REPRODUCED, USED, OR DISCLOSED
TO OTHERS UNLESS PRIOR WRITTEN AUTHORIZATION IS OBTAINED.
13131 WEST LITTLE YORK ROAD, HOUSTON, TX 77041 U.S.A.
4300 Series Installation and Operation Manual
1.75"
39561
1.00"
PN 40830
TITLE:
TITLE:
DANGER LABEL
WARNING LABEL
CAPACITORS
PLP
WARNING AREA
TEXT AREA
DRAWING NO.:
DRAWING NO.:
40830
39
Advertisement
Table of Contents
