GE 60-960-95 Installation Instructions Manual page 46

Concord ultra

Hide thumbs Also See for 60-960-95:

Table of Contents

Low CPU Battery (06004)

When this setting is on, the panel reports a low panel battery to the

central station before shutting down.

Note

For UL 1635 listed installations, this feature must be set to on.

Battery Restoral (06005)

If this setting is on, the panel reports to the central monitoring sta-

tion when a wireless sensor or touchpad reports a battery replace-

ment to the panel.

Buffer Full Rpt (06006)

When this setting is on, the panel sends an "event buffer full"

report to the central monitoring station when the event buffer is

nearly full.

Zone Restorals (06007)

When this setting is on, the panel reports a restoral to the central

monitoring station for wireless or hardwire zones in alarm before

the alarm is canceled.

Note

As with all GE Security panels, hardwire smoke detectors connected to

Concord Ultra or SnapCard hardwire zones do not send restorals.

Two Trip Error (06008)

This setting works with the Alarm Verify setting (see "Alarm Ver-

ify" later in this section and Appendix B: Table B1 "Sensor Table

Characteristics"). If Alarm Verify is on, then the panel waits for a

second sensor trip before sending an alarm.

Note

For UL Listed installations, this feature must be set to off.

If Two Trip Error is also on and a second sensor trip does not occur

within a 4-minute time period, then the panel sends an error report

to the central monitoring station.

Reporting-Global (Default = on)

To turn Low CPU Battery reports off or on:

With the display showing

(current setting), press 1 (off) or 2 (on). The display

flashes the entered setting.