GE 60-960-95 Installation Instructions Manual page 33

Phone Number (cs phone 1: 0100, cs phone 2: 0110, cs phone
3: 0120)
This setting is used for programming the central station receiver phone number.
Phone numbers can be 1 to 24 digits long, including pauses or * and # charac-
ters.
To enter pauses, press C.
To enter *, press and hold 7 for about two seconds.
To enter #, press and hold 9 for about two seconds.
Note
The menus are not accessible if a Dealer Code is programmed and the
PHONE NUMBER
Installer Code is used to enter installer programming mode. To access these menus
when a Dealer Code is programmed, you must enter installer programming mode
using the Dealer Code.
Call-waiting services should be disabled to prevent interrupting panel communication
to the central monitoring station. To program a dialing prefix that disables call-waiting,
see the Call Wait Cancel setting under the menu
For UL 1635 listed installations, a phone number must be programmed.
High Level Rpts (cs phone 1: 0101, cs phone 2: 0111, cs
phone 3: 0121)
When this setting is on, the following conditions report to the central station:
• Fire, Police, Auxiliary, and Duress alarms
• No Activity
• Receiver Failure (or jam)
• Tamper conditions, including Zone Tampers and System Tamper (40 incor-
rect key presses or touchpad supervisory)
• Entering or exiting Sensor Test mode
• Phone Test
Note
For UL 1635 listed installations, this feature must be set to on.
Low Level Rpts (cs phone 1: 0102, cs phone 2: 0112, cs phone
3: 0122)
When this setting is on, the following non-alarm conditions report to the central
station:
• Force Armed
• Hardwire Zone Trouble (open or short)
• Supervisory (wireless devices)
• Low Battery (wireless devices)
• Phone Test
• Other non-alarm related conditions
Note
For UL 1635 listed installations, this feature must be set to on.
Concord Ultra
PHONE OPTIONS—GLOBAL
.
Phones-CS Phone 1-3 (Default = none)
¾
To program a Central Station Phone
Number:
1. With the display showing
(or current number), enter the
BER _
desired phone number. The display
flashes the entered number.
2. Press # and the display shows the new
number.
¾
To delete a Central Station Phone Num-
ber:
1. With the display showing
(current number), press D. The dis-
BER
play shows
HONE NUMBER _
P
Phones-CS Phone 1-3 (Defaults: CS
Phone 1 = on, CS Phone 2&3 = off)
¾
To turn High-Level Reports off or on:
1. With the display showing
(current setting), press 1
RPTS OFF/ON
(off) or 2 (on). The display flashes the
entered setting.
2. Press # and the display shows the new
setting.
Phones-CS Phone 1-3 (Defaults: CS
Phone 1 = on, CS Phone 2&3 = off)
¾
To turn Low-Level Reports off or on:
1. With the display showing
(current setting), press 1
RPTS OFF/ON
(off) or 2 (on). The display flashes the
entered setting.
2. Press # and the display shows the new
setting.
PHONE NUM-
PHONE NUM-
.
HIGH LEVEL
LOW LEVEL
28