Connecting The Outdoor Power Supply; Connecting A Wla To A Wlc - Juniper WLA620 Installation Manual

Installing and Connecting an Access Point
Figure 3–6. Attaching an Ethernet Cable to the WLA620
Connecting the Power Supply
Contact a fully qualified electrician to perform the installation.
Connecting an WLA to an WLC
You can connect an WLA directly to an WLC or indirectly to the WLC through an
intermediate Layer 2 or Layer 3 network. If you are connecting the WLA directly to an
WLC, use the following procedure to insert the cable into the WLC and verify the link.
You can use the CLI or RingMaster to configure an WLA connection. If you are installing
the WLA620 as a Mesh WLA in a WLAN Mesh or wireless bridge configuration, you
must configure the WLA connection before deploying the WLA620 in its final location.
Figure 3–7 below shows how to insert a Cat 5 cable into 10/100 Ethernet port on an
WLC. Refer to this figure as you perform the procedure.
Figure 3–7. 10/100 Cat 5 Cable Installation
1. Insert a Cat 5 cable with a standard RJ45 connector as shown in Figure 3–7. For
connection to an WLA, use a straight-through cable.
2. When the link is activated, observe the WLA LED for the port on the WLC:
8
Ethernet Cable
(Cat 5 cable)
Ethernet port
WLA, server or
other device
Copyright © 2012, Juniper Networks, Inc.