Juniper WLA620 Installation Manual page 69

Table 5: WLC Port LEDs for WLA Connections
WLC Port LEDs for WLA
Connections
Solid green
Alternating green and amber
Solid amber
Blinking amber
Unlit
Alternating green and amber
Solid amber
Informational Note:
ports by default. You must change the port type for an WLC port directly connected to a
WLA to activate the link.
Copyright © 2012, Juniper Networks, Inc.
Meaning
For an WLA active link, all the following are true:
WLA has booted.

WLA has received a valid configuration from the WLC switch.

Management link with an WLA is operational.

At least one radio is enabled or is in sentry mode.

For an WLA secondary link, the link is present.
WLA is booting with an image received from the WLC switch. After the access point
boots and receives its configuration, this LED appearance persists until a radio is
enabled or is placed in sentry mode.
PoE is on.
WLA is unresponsive or there is a PoE problem.
PoE is off.
WLA is booting with an image received from the WLC switch. After the access point
boots and receives its configuration, this LED appearance persists until a radio is
enabled or is placed in sentry mode.
PoE is on.
The WLC 10/100 Ethernet ports are configured as wired network
Installing and Connecting an Access Point
35