Juniper WLA620 Installation Manual page 75

This device is going to be operated in 5.15~5.25GHz frequency range, it is restricted in
indoor environment only..
Caution:
must be professionally installed to ensure compliance with the Part 15 certification. It is the
responsibility of the operator and professional installer to ensure that only certified
systems are deployed in the United States. The use of the system in any other combination
(such as co-located antennas transmitting the same information) is expressly forbidden.
Caution:
radiation exposure limits set forth for an uncontrolled environment. This equipment should
be installed and operated with minimum distance 20cm between the radiator and your
body
Caution:
System are responsible for the proper setup and operation in accordance to all rules and
regulations of the country in which the equipment operates.
Canadian Department of Communications Industry Canada
Notice (Canada)
This digital apparatus meets the requirements of Canadian Interference-Causing
Equipment Regulation RSS-210.
This Class B digital apparatus complies with Canadian ICES-003.
Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
Cet appareil numérique de la classe B conforme á la norme NMB-003 du Canada.
Country Code Statement: For product available in the USA/Canada market, only
channel 1~11 can be operated. Selection of other channels is not possible.
This device and its antenna(s) must not be co-located or operation in conjunction with
any other antenna or transmitter.
To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (e.i.r.p) is not more
than that permitted for successful communication.
This device has been designed to operate with the antennas listed below, and having a
maximum gain of [23.5] dB. Antennas not included in this list or having a gain greater
than [23.5] dB are strictly prohibited for use with this device. The required antenna
impedance is 50 ohms.
The device could automatically discontinue transmission in case of absence of
information to transmit, or operational failure. Note that this is not intended to prohibit
transmission of control or signaling information or the use of repetitive codes where
required by the technology.
The device for the band 5150-5250 MHz is only for indoor usage to reduce potential for
harmful interference to co-channel mobile satellite systems.
The maximum antenna gain permitted (for devices in the band 5725-5825 MHz) to
comply with the e.i.r.p. limits specified for point-to-point and non point-to-point operation
as appropriate, as stated in section A9.2(3).
Copyright © 2012, Juniper Networks, Inc.
FCC Notice: To comply with FCC part 15 rules in the United States, the system
FCC Radiation Exposure Statement: This equipment complies with FCC
System Administrators and anyone involved in the installation of the WLAN
WLA Series Technical Specifications
5