Power Requirements For Ap12 - Juniper AP12 Deployment Manual

Table 2: Specifications for AP12
Parameter
Radio frequency (RF)
Maximum PHY rate (maximum
transmit rate at the physical
layer)
Maximum devices that each
radio supports

Power Requirements for AP12

The AP12 requests 12.9 W to provide wireless only functionality. The AP12 requires 802.3at power
when you use the PoE out functionality. The AP can provide 7 W of PoE out. If you don't need to use
PoE out, the AP can operate with full functionality using 802.3af power. You can use any of the
following options to power on an AP12:
• Power over Ethernet Plus (PoE+) from an Ethernet switch
We recommend that you use an Ethernet cable with a maximum length of 100 m to connect the
access point (AP) to the switch port.
If you use an Ethernet cable that is longer than 100 m by placing an Ethernet PoE+ extender in the
path, the AP might power up, but the Ethernet link does not transmit data across such a long cable.
You might see the status LED blink yellow twice. This LED behavior indicates that the AP is unable to
receive data from the switch.
• PoE injector
(Continued)
Description
•
5 GHz radio—Supports 2x2:2SS 802.11ax MU-MIMO and SU-MIMO
•
2.4 GHz radio—Supports 2x2:2SS 802.11ax MU-MIMO and SU-MIMO
•
2.4-GHz or 5-GHz scanning radio
•
2.4-GHz Bluetooth® Low Energy (BLE) with omni antenna
•
Total maximum PHY rate—1775 Mbps
•
For the 5-GHz radio—1201 Mbps
•
For the 2.4-GHz radio—574 Mbps
512
9