Table of Contents
Advertisement
AP61 Power Requirements
AP61 requires 802.3at (PoE+) power. To provide full wireless functionality, the AP61 requests 19.5 W.
You can use any of the following options to power on the AP:
• Power over Ethernet Plus (PoE+) from an Ethernet switch
We recommend that you use an Ethernet cable with a maximum length of 100 m to connect the
access point (AP) to the switch port.
If you use an Ethernet cable that is longer than 100 m by placing an Ethernet PoE+ extender in the
path, the AP might power up, but the Ethernet link does not transmit data across such a long cable.
You might see the status LED blink yellow twice. This LED behavior indicates that the AP is unable to
receive data from the switch.
• PoE injector
10
Advertisement
Table of Contents
