Figure 3–15. Attaching an Ethernet Cable to the WLA622
Connecting the Power Supply Unit
Contact a fully qualified electrician to perform the installation.
To connect the wireless bridge to a PSU:
Informational Note:
over Ethernet (PoE) based on the IEEE 802.3af standard. Do not try to power the unit by
connecting it directly to a WLC that provides IEEE 802.3af PoE. For power, always connect
the unit only to the included WLA-XPS9001GO PSU.
1. Connect the Ethernet cable from the wireless bridge to the PoE port labeled "DATA
PWR OUT" on the PSU..
Copyright © 2012, Juniper Networks, Inc.
The Ethernet port on the wireless bridge does not support Power
Installing and Connecting an Access Point
19