Connecting The Access Point To Wireless Lan Controllers - Juniper WLA532 Hardware Documentation

Hide thumbs Also See for WLA532:

Hardware documentation (64 pages)

Table Of Contents

Table of Contents

Documentation

Connecting the Access Point to Wireless LAN Controllers

Documentation

Installing the WLA532 Access Point on a Suspended Ceiling Rail on page 33

You can connect a wireless LAN access point to a Wireless LAN controller (WLC) directly

or indirectly through an intermediate layer 2 or layer 3 network.

To connect the access point directly to a WLC:

Insert one end of a Category 5 cable with a standard RJ-45 connector to the ethernet

port of the access point and the other end to ethernet port of the controller. For

connection to an access point, use a straight-through signaling cable.

Observe the access point LED for the port on the controller.

The link is activated if the LED is green and glowing steadily.

To configure the access point connection, use the RingMaster GUI or the Mobility System

Software CLI.

If you are installing the access point in a Wireless LAN mesh or wireless bridge

configuration, you must configure the access point connection before deploying the

access point in the final location. For more information, see the Mobility System Software

Configuration Guide or the Configuration Guide.

Mobility System Software Configuration Guide at

h t t p : / / w w w . j u n i p e r . n e t / t e c h p u b s / e n _ U S / r e l e a s e - i n d e p e n d e n t / w i r e l e s s / i n f o r m a t i o n - p r o d u c t s / p a t h w a y - p a g e s / w i r e l e s s - l a n / s o f t w a r e - 7 5 . h t m l

Installing the Access Point

Table of Contents