Ap63 Power Requirements - Juniper AP63 Deployment Manual

AP63 Power Requirements

AP63 requires 802.3at (PoE+) power. The AP63 requests 25.2 W to provide full wireless functionality.
You can use any of the following options to power on the AP:
• Power over Ethernet plus (PoE+) from an Ethernet switch
We recommend that you use an Ethernet cable with a maximum length of 100 m to connect the
access point (AP) to the switch port.
If you use an Ethernet cable that is longer than 100 m by placing an Ethernet PoE+ extender in the
path, the AP might power up, but the Ethernet link does not transmit data across such a long cable.
You might see the status LED blink yellow twice indicating that the AP is unable to receive data from
the switch.
• PoE injector
9