Typical RRPP Networking
Here are several typical networking applications.
Single ring
As shown in
Figure
define an RRPP domain.
Figure 1-2 Schematic diagram for a single-ring network
Tangent rings
As shown in
Figure
between rings. In this case, you need to define an RRPP domain for each ring.
Figure 1-3 Schematic diagram for a tangent-ring network
Intersecting rings
As shown in
Figure
between rings. In this case, you only need to define an RRPP domain, and configure one ring as the
primary ring and the other rings as subrings.
1-2, there is only a single ring in the network topology. In this case, you only need to
1-3, there are two or more rings in the network topology and only one common node
1-4, there are two or more rings in the network topology and two common nodes
1-7