Access Volume Organization
Manual Version
6W101-20100310
Product Version
V05.02.00
Organization
The Access Volume is organized as follows:
Features
Ethernet Port
Ethernet Link
aggregation
Port Isolation
This document describes:
Combo Port Configuration
Basic Ethernet Interface Configuration
Configuring an Auto-negotiation Transmission Rate
Configuring Flow Control on an Ethernet Interface
Configuring the Suppression Time of Physical-Link-State Change on
an Ethernet Interface
Configuring Loopback Testing on an Ethernet Interface
Configuring a Port Group
Configuring a MAC Address for an Ethernet Port
Configuring Storm Suppression
Setting the Interval for Collecting Ethernet Interface Statistics
Enabling Forwarding of Jumbo Frames
Enabling Loopback Detection on an Ethernet Interface
Configuring the MDI Mode for an Ethernet Interface
Testing the Cable on an Ethernet Interface
Configuring the Storm Constrain Function on an Ethernet Interface
Link aggregation aggregates multiple physical Ethernet ports into one
logical link. This document describes:
Basic Concepts of Link Aggregation
Configuring a Static Aggregation Group
Configuring a Dynamic Aggregation Group
Configuring an Aggregate Interface
Configuring Load Sharing Criteria for Link Aggregation Groups
The port isolation feature allows you to isolate different ports within the
same VLAN. This document describes:
Introduction to Port Isolation
Configuring the Isolation Group
Description