Frequency Response Adjustments Setup (10 Mhz To - HP 8566B Adjustment Manual

Segment frequency breakpoints in all preselected frequency bands
(Bands B, C, D, and E, 2 GHz - 22 GHz).
16. Adjust 17-turn potentiometer A6A12R113 -9 V for a DVM
indication of -9.000 fO.OO1 Vdc. See Figure 3-90 for the
location of A6A12R113.
17. Press C2--22J on the spectrum analyzer. Set the controls of the
spectrum analyzer as follows:
CENTER FREQUENCY . . . . . . . . . . . . . . . . . . . . . . . . . 0 Hz
FREQUENCY SPAN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .O Hz
SWEEP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SINGLE
18. Use a BNC cable and a BNC (f) to dual banana plug adapter to
connect the DVM to the RF Section rear-panel SWEEP+TUNE
OUT connector.
19. Adjust 25-turn potentiometer A6A12R98 ZERO for a DVM
indication of 0.000 fO.OO1 Vdc. See Figure 3-90 for the location
of A6A12R98.
20. Connect the equipment as shown in Figure 3-91, with one
resistive output of the power splitter connected to the power
meter/power sensor using an APC 3.5
and the second resistive output connected to the spectrum
analyzer RF INPUT using an APC 3.5 (m) to Type N (m) adapter.
Connect the power meter rear panel RECORDER OUTPUT to the
synthesized sweeper front panel LEVELING EXT INPUT.
21. Press )
PRESET
of the synthesized sweeper as follows:
CW . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100 MHz
POWER LEVEL . . . . . . . . . . . . . . . . . . . . . . . . . . -9.0 dBm
RF . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . on
LEVELING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .INT
Frequency Response Adjustments Setup (10 MHz to 2.5 GHz)
2 1. Frequency Response Adjustments
(m) to Type N (f) adapter,
on the synthesized sweeper. Set the controls
Figure 3-91.
-9
V affects
Adjustments 3-179