Location Of Ala2, Ala4, Ala5, And A3A2; Ala2, Ala4, And Ala Adjustment Locations - HP 8566B Adjustment Manual

3. Preliminary Display Adjustments (SN 3001A and Below)
Figure 3-17. Location of AlA2, AlA4, AlA5, and A3A2
R 2 2
\
Figure 3-18. AlA2, AlA4, and AlA Adjustment Locations
10. Set the pulse/funtion generator controls as follows:
MODE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . NORM
Waveform . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..pulse
Frequency (FRQ) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .200 kHz
Width (WID) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 250 ns
Amplitude (AMP) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2.00 V
Offset (OFS) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .OOO mV
Disable . . . . . . . . . . . . . . . . . . . . . . . . . . . . off (OUTPUT enabled)
11. Connect the output of the pulse/function generator to Jl (X input)
on the Display Adjustment PC board in the A3A2 slot as shown in
Figure 3-16.
The pulse/function generator output must be terminated with 50
ohms. Use a BNC tee, a 500 termination, and a BNC female to SMB
female adapter. Install the 500 termination as close to the Display
Adjustment PC Board as possible.
G A I N
11 E.2