Table of Contents
Advertisement
5.3.5.
The Actual Load Linearization Function
Set the digital linearization by loading/unloading masses.
Warm up the module for at least ten minutes to avoid the effects of temperature drift.
The input order should proceed from the smallest mass to the largest mass.
Step 1
Press the
display
and display
and press the
Step 2
If monitoring the current weighing value, press the
When pressing the
Step 3
Placed nothing on the pan and wait for the stabilization (
Press the
two seconds.
Step 4
If you want to check the current weighing value, press the
When pressing the
Press the
capacity) is displayed and the least digit of the value blinks.
Correct the value using the
weight value used.
Step 5
Place the weight on the pan. Wait for the stabilization (
Press the
two seconds.
Step 5
proceeds in order of
Step 7
If finishing the input, proceed to step 8.
If you want to re-input the digital linearization, select the input point
using the
cleared.
Step 8
Press the
data will be stored in the FRAM. At the same time, the calibrated
data is also refreshed. Press again the
weighing mode.
If
X
Refer to "5.3.8. Error Codes For The Calibration" to take some measures.
The blinking decimal point means that the current value is not the weight value.
AD-4430B
+
key to enter to the calibration mode and
. Press the
. Select
key.
is displayed.
key again,
key.
is displayed.
key again,
key. The weight value (the current weighing
key.
is displayed. Repeat step 4 and step 5. The procedure
key. All data following the new input point will be
key.
is displayed, an error has occurred. X : number.
key to start the calibration
using the
is display.
is displayed for approximately
is displayed.
and
key so as to be the
is displayed for approximately
→
→
is displayed and the inputted
key to return to
- 23 -
key
key.
LED ).
key.
Example
LED ).
.
Advertisement
Table of Contents
