Table of Contents
Advertisement
5.3.2.
The Calibration With An Actual Load (Using A Mass)
Calibration is performed using a calibration weight. Before performing calibration for the first
time, set the unit, decimal point position, minimum division and weighing capacity in the
calibration-related function mode (
Note To avoid drift caused by changes in temperature, warm up the indicator for ten
minutes or more before performing calibration with an actual load.
Step 1
In the OFF mode (Standby), Press the
the calibration mode and display
Step 2
Press the
If returning to the weighing mode, press the
Zero Calibration
Step 3
Press the
If zero calibration is not to be performed, press the
proceed to step 5. If you want to check the current weighing value,
press the
is display.
Step 4
Placed nothing on the pan and wait for the stabilization (
Press the
two seconds. If span calibration is not performed, press twice the
key for returning to the weighing mode.
Span Calibration
Step 5
Press the
calibration weight value (the current weighing capacity) is
displayed and the least digit of the value blinks. Correct the value
using the
calibration weight used. If span calibration is not performed, press
three times the
Step 6
Place the calibration weight on the pan. Wait for the stabilization
(
LED ). Press the
approximately two seconds.
Step 7
Step 8
Press the
calibration data is stored in the memory.
Step 9
The current state is the same as that of step 2. If returning to the weighing mode, press
the
If
X
Calibration" to take some measures. X : number.
The blinking decimal point means that the current value is not the weight value.
key to start the calibration and display
key to display
key. When pressing the
key.
key when
and
key so as to be the value of the
key for returning to the weighing mode.
key.
is displayed.
key.
key.
is displayed, an error has occurred. Refer to "5.3.8. Error Codes For The
C-Fnc
).
+
.
.
key again,
is displayed for approximately
is displayed. The
is displayed for
is displayed and the
- 20 -
key to enter to
.
key.
key and
LED ).
Example
AD-4430B
Advertisement
Table of Contents
