Accessing The Internal Components; Opening The Server Case - Gateway E-9232T User Manual

•
•

Accessing the internal components

Opening the server case

included) before you turn on the server. Operating the server without the cover in place
can damage server components.
Because the components inside your server are extremely sensitive to static electricity, make sure
that you follow the instructions at the beginning of this chapter to avoid static electricity damage.
To open the server case:
1
2
3
4
www.gateway.com
Remove components from their antistatic bags only when you are ready to use them. Do
not lay components on the outside of antistatic bags because only the inside of the bags
provide electrostatic protection.
Always hold expansion cards by their edges or their metal mounting brackets. Avoid
touching the edge connectors and components on the cards. Never slide expansion cards
or components over any surface.
Caution
For correct cooling and air flow, always reinstall the side panel and the air duct (if
Follow the instructions in
Turn off the server, then unplug the power cords and all other cables connected to the
server.
Warning
This server may have two power cords. To disconnect internal AC power,
you must unplug both power cords.
Remove the case cover thumbscrew.
Lift the cover release lever.
"Preventing static electricity discharge" on page 18.
19