Combo(3+1) Ports, Int Jump Set For 10/100 Rj-45 Auto-Neg - GarrettCom Quad Installation And User Manual

Garrett communications fiber switches installation and user guide magnum quad
Table of Contents

Advertisement

Magnum Quad-Series Fiber Switches
configuration(specially along with switches). Under certain conditions,(where the
connected device is half duplex and does not support full-duplex; or the connected device
does not support full-duplex properly) no full-duplex is better and the internal jumper
settings will permit this to be selected on a per-port basis.
3.6 Combo(3+1) ports, internal jumper settings for 10/100 RJ-45 Auto-
Negotiation or 100Mb fiber fixed Half- or Full-Duplex , per port
Jumper Settings for 10/100Mbps RJ-45 Auto-Negotiation, 100Mbps Fiber Half or Full Duplex
Jumper
JP2 -3, 6-7, 10-11
JP1-2, 6-7, 9-10
JP1-2, 7-8, 11-12
Factory Settings
For RJ-45 ports only
9 10 11 12
)
J1
5
6 7
8
1
2
3
4
Printed Circuit card
2 3 1
4
Figure 3.6 Combo ports, RJ-45 and Fiber internal jumper settings.
Note: Be certain that the main power is disconnected before opening the unit or
changing any internal jumper settings
The factory (default) setting is Auto-Negotiation on all RJ-45 ports and full-
duplex on fiber 100Mbps ports, which is generally popular. Auto-Negotiation on RJ-45
and FDX on fiber port works well under most circumstances, but cannot always be
depended upon to work as expected. If full-duplex will not function properly in your
setup, internal jumpers allow the speed and mode of the Q-Series Combo- quad ports to
be fixed, even if the attached device may or may not support full-duplex. This is
www GarrettCom com
.
Port
Pin 2-3, 6-7, 10-11
Pin 1-2, 6-7, 9-10
Pin 1-2, 7-8, 11-12
10/100 Mbps
Auto Negotiation
J1
10/100 Mb
1 2
3 4
AUTO
TOP
.
Installation and User Guide (06/09)
Factory Settings
Function
Auto-Negotiation
YES
FDX @100 config
HDX@100 config
NO
100Mbps Full
1
Duplex
J1
100 Mb
1 2 3
4
For RJ-45 &
Fiber port
Jumper Settings for HDX/FDX
J1
J2
J3
J4
LED
22
Speed
10/100 Mb(RJ-45)
100 Mb(Fiber)
YES
100 Mb(Fiber)
100Mbps Half
Duplex
J1
100 Mb
1 2 3
4
For RJ-45 &
Fiber port
Bottom QPM Retaining
Two(50) Pin
QPM Connectors
(inserts into main board
)

Advertisement

Table of Contents
loading

Table of Contents

Save PDF