Viewing Disablements - Zeta NPAD 2 Installation Manual

PREMIER AD INSTALLATION MANUAL.
press the disable button again. Note that the Zone disablement LED for this address will not light
because this would suggest that the whole zone is disabled, so would be misleading.

13.4 VIEWING DISABLEMENTS

There are two ways to check for disablements: from the Disablement screen, or from the device
status screen.
To view from the disablement screen, press disable, then press select to scroll through all the zones
& sounders.
If there are no disablements, the screen will show
If the whole zone is disabled, the screen will show
If there are one or more disabled points in this zone, the screen
will show.
(TIP: a quick way to enable several disabled points is to
disable the zone, then re-enable it)
To view from the Device Status screen, press enter then option 2 to select Device Status
If a device is enabled, the screen will show
If a device is disabled, the screen will show
(Note that line 3 will flash between the device label and
Device Disabled Message)
If a device is in a disabled zone, the screen will show
(Note that line 3 will flash between the device label and
Zone Disabled Message)
Approved Document No: GLT.MAN-105A
Issue : 2.02 Authorised: GH Date: 16/07/2007
Software:PANEL:R1107 & LOOP:R1062
Zone Disablement
Zone 1
Enabled
Single Devices:
Zone Disablement
Zone 1
Disabled
Single Devices:
Zone Disablement
Zone 1
Enabled
Single Devices:
Optical
Analog: 25 Normal
Fl 3 Bedroom 303
Zone:01 Lp:1 Ad:016
Optical
Analog: 25 Normal
Device Disabled
Zone:01 Lp:1 Ad:016
Optical
Analog: 25 Normal
Zone Disabled
Zone:01 Lp:1 Ad:016
0
0
2
PAGE 24