Accessory Grille Panel Kits; Installation Examples - Monogram ZIRS36N LH Installation Instructions Manual

Design Information
36" Stoinless Steel Refrigerotors, Freezers
Side By Side
Installation
Of Freezer
And Refrigerator
t *Finished Width
84-1/2"max
83-1/2"rain
Finished
Opening
For a complete food storage centec install a
Monogram Freezer and Refrigerator side bg side.
For even more capacitg, install two refrigerators
and one or two freezers.
• Order ZUGSS Unified Grille Panel Kit for one
continuous stainless steel grille panel.
• Electrical and water locations must be
located as shown for either tgpe of installation.
A separate 115V, 60Hz, 20 amp power supplg
is recommended for each product.
5"
24-3/4" Total
Depth
5"
WallView
75"From Floor
to Bottom
ofElectrical
Area
Freezer Refrigerator
*72" min. for a flush installation
71-1/2" min. for a semi-flush installation
NOTE:Additional cutout width ma N be required when side
panels are used. Add side panel thickness to the finished
cutout to calculate rough-in width. See installation examples
below.
Accessory
Grille Panel
Kits
These models are factorg set for 84" installation
height. Adjustments to 85-1/2" or 84-1/2" heights
can be made bg changing the grille panel.
Order ZGCSS36RH(right hand) or ZGCSS36LH
(left hand) Grille Panel Kit. These kits include 2 grille
panels, for 83-1/2" and 84-1/2" installation heights.
ZUGSS Unified Grille Panel Kit
For side bg side installation, order ZUGSS grille panel
kit. This kit provides one continuous panel to span
the width of two products installed together for a
unified appearance.
Installation
Examples
Side panels are required whenever the sides of the
product will be exposed.
1/2" to 3/4" side panels are normallg set into place
and fastened to adjacent cabinetrg or to the back
wall before rolling the refrigerator or freezer into
the opening.
Therefore, the rough-in dimensions must allow for
side panel thickness. In both a flush and semi-flush
installation, the finished dimension (the width of
the opening after side panels are installed) must
accommodate the full width of the product.
See page 10 for side panel sizes.
Installation
Between
Base and
Wall Cabinets
Refrigerator or Freezer
I II1/4"Thick II I
Finished D im_3.
5-1/2' 1
Rough-In Dim. _36'_ I
NOTE: 1/4"thick side panels can be
inserted into the case trim, making the
rough-in the same as the outside trim
width: 56".
liiiii
Refrigerat0r_
Refrigerator door _
Cabinet